Electric rolling shutter door has a good windproof safety function and high safety performance. It is also used in food and pharmaceutical industry and most warehouses. Visible electric rolling shutter door has been widely used in all walks of life. Electric rolling shutter door has been widely used in commercial facade, garage, shopping malls, hospitals, factories and enterprises and other public places, so how to extend the service life of its electric rolling shutter door? Let's follow Xiaobian and have a look.

1、電動卷簾門在檢修開閉過程中，應具有就地停止的功能，不應停止并繼續滑動，如果滑動距離大于50毫米，應立即仔細檢查和修理電動卷簾門控制裝置和簾門制動，直到正常工作。

1. The electric rolling shutter door shall have the function of local stop in the process of maintenance opening and closing, and shall not stop and continue to slide. If the sliding distance is greater than 50 mm, the control device of electric rolling shutter door and the brake of curtain door shall be carefully checked and repaired immediately until it works normally.

2、電簾門窗簾及生銹部分，應定期進行防腐、油漆及維修處理，嚴禁重物、硬物對立面的沖擊。

2. The curtain and curtain are not allowed to be rusted and rusted, and the curtain should be treated regularly.

3、伸縮門檢修基梁的上限位置必須與軸承架下端保持200mm以上的距離，以制動停止時不發生頂部撞擊。

3. The upper limit of the inspection base beam of the telescopic door must be kept at a distance of more than 200 mm from the lower end of the bearing frame, so that the top impact will not occur when the brake stops.

濟南電動卷簾門

Jinan electric rolling shutter door

4.電幕門安裝位置上端應有的防火設施。在電動窗簾門鼓下端制造箱體或天花板時，必須設置可拆卸的活動蓋板，并在電動門機下端預留500×500 mm可拆檢修孔，以便于維修保養。

4. There should be fire prevention facilities at the upper end of the installation position of the electric curtain door. When manufacturing the box or ceiling at the bottom of the electric curtain door drum, a removable movable cover plate must be set up, and a 500 × 500 mm removable access hole must be reserved at the lower end of the electric door machine for maintenance.

5.所有電動卷簾門，運行電控的方向快門必須是開關盒所指示的相同，尤其是當新的功率汽車或外國輸入功率轉換階段，維修電動卷簾門馬達的應該是一個手動裝置簾放置1/2車門打開位置，功率門操作卷后的試驗操作的高度，直到該附件相和指令，在正常使用之前，以其他方式損壞止動件，使得所述反繞卷簾或類似物提升和損失。

5. For all electric rolling shutter doors, the direction of operating electric control shutter must be the same as that indicated by the switch box, especially when the new power automobile or foreign input power conversion stage, the maintenance of electric rolling shutter door motor should be a manual device, the curtain should be placed at 1 / 2 of the door open position, and the test operation height after the power door operates the roll up, until the accessory phase and command, before normal use The stopper is damaged in other ways, so that the reverse winding shutter or the like is lifted and lost.

6、伸縮門維修和操作時，操作人員必須站在能看到卷簾門運行狀態的位置，否則容易發生事故和損壞。

6. During the maintenance and operation of the retractable door, the operator must stand at the position where he can see the running state of the rolling shutter door, otherwise it is easy to cause accidents and damages.

7、禁止電動百葉窗門簾和門簾卷繞機與酸性、堿性溶液接觸，防止門簾表面腐蝕。

7. It is forbidden to contact the electric shutter curtain and curtain winding machine with acid and alkaline solution to prevent the surface corrosion of the curtain.

8、.電動卷簾門門輥運行，滑行時，驅動器和其它部件應定期檢查（每年少兩次），和燃料需要及時，以正常使用的電動卷簾門的。

8. When the roller of electric rolling shutter door is running and sliding, the driver and other parts shall be inspected regularly (at least twice a year), and the fuel shall be timely used for the electric rolling shutter door.