The rolling shutter door or electric door is operated by remote control. Generally speaking, the garage or some shops use it more, but if you can't open the rolling shutter door, it will delay a lot of things. In the process of use, the remote control of the rolling shutter door will be on, but there is no response. What is the reason for this? How should we solve it?

一、卷簾門遙控器會(huì )亮，但是沒有反應

1、 The remote control of the rolling shutter door will light up, but there is no response

1、如果出現這樣的問題，有可能是電池電量不足，只要更換新的電池再試一下就能夠解決問題了。

1. If there is such a problem, it may be that the battery is out of power. As long as you replace the battery and try again, you can solve the problem.

2、如果遙控的距離比較遠，也會(huì )導致遙控器沒有反應，我們可以靠近一點操作再試一試。

2. If the remote control distance is relatively far, it will also cause the remote control not to respond. We can operate closer and try again.

3、如果遙控器使用時間已經比較久了，電路板已經老化了，就會(huì )導致遙控器失靈，我們可以打開遙控器清洗一下。如果遙控器已經損壞，直接更換一個新的就可以了。尤其是如果遙控器出現掉碼的問題，就屬于質量問題，可以請的售后服務人員來維修

3. If the remote control has been used for a long time and the circuit board has aged, the remote control will fail. We can open the remote control and clean it. If the remote control has been damaged, just replace it with a new one. In particular, if the remote control code drop problem, it belongs to the quality problem, you can ask professional after-sales service personnel to repair

二、卷簾門遙控器的使用方法

2、 How to use the remote control of rolling shutter door

1、使用卷簾門遙控器的時候，需要確定使用的是哪種型號的遙控器，要知道芯片的型號。使用之前需要清碼，可以看到遙控器上面有兩個按鍵，指示燈閃一次之后我們就可以再按一下，之后就能夠成功。

1. When using the remote control of rolling shutter door, it is necessary to determine which type of remote controller is used and to know the model of chip. You need to clear the code before using it. You can see that there are two buttons on the remote control. After the indicator light flashes once, we can press it again. After that, it can be cleared successfully.

2、使用遙控器要進行對碼，比如遙控器和對碼的遙控器放在一起，同時按下任意的一個鍵，這時候就會(huì )看到它的指示燈會(huì )閃一下，就表明復制成功了，前后可能只有1~2秒鐘，再按照相同的辦法把其他的三個按鍵都要對上。

2. If you use the remote control, you need to check the code. For example, if you press any key at the same time, you will see that the indicator light will flash, indicating that the copy is successful. It may be only 1-2 seconds before and after. Then, according to the same method, the three buttons should be aligned.

三、遙控器出現故障維修辦法

3、 Troubleshooting of remote control

1、遙控器如果出現了失靈，有可能是電池沒有電了，或者內部的結構出現了問題，它里面有一個接觸器或者電動的開關，一旦這些配件出現問題就需要重新更換。

1. If the remote control fails, it may be that the battery is out of power, or there is a problem with the internal structure. There is a contactor or electric switch in it. Once these accessories have problems, they need to be replaced.

2、卷簾門工作的時候可能會(huì )出現不動或者轉得比較慢，有可能是負荷較大，或者線路被燒斷了，需要檢查維修電路，并且要把它接通或者卷簾門有什么東西被卡住，需要清理一下。

2. When the rolling shutter door is working, it may not move or rotate slowly. It may be that the load is large, or the circuit is burnt out. It is necessary to check and repair the circuit and turn it on. Or something is stuck in the rolling shutter door, which needs to be cleaned up.